Ip Ospf Bfd-State All-Interfaces - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip ospf bfd-state all-interfaces

ip ospf bfd-state all-interfaces
Enables or disables BFD for all OSPF interfaces in the switch configuration.
ip ospf bfd-state all-interfaces {enable | disable}
Syntax Definitions
enable
disable
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
The BFD status for OSPF must be enabled before OSPF can interact with BFD.
Examples
-> ip ospf bfd-state all-interfaces enable
-> ip ospf bfd-state all-interfaces disable
Release History
Release 7.1.1; command was introduced.
Related Commands
ip ospf bfd-state
ip ospf interface bfd-state
ip ospf interface bfd-state drs-
only
ip ospf interface bfd-state all-
neighbors
MIB Objects
alaProtocolospf
alaOspfBfdAllInterfaces
page 14-16
Enables BFD for all the OSPF interfaces.
Disables BFD for all the OSPF interfaces.
Enables or disables the BFD status for the OSPF protocol.
Enables or disables BFD for a specific OSPF interface.
Establishes BFD sessions only on neighbors in full state.
Establishes BFD sessions with all neighbors of the corresponding
interface which are greater than or equal to "2-way" state.
OmniSwitch CLI Reference Guide
BFD Commands
March 2011