Vrrp - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

VRRP Commands

vrrp

Configures a new VRRP virtual router or modifies an existing one. Used to enable or disable a virtual
router.
vrrp vrid vlan_id [enable | disable | on | off] [priority priority] [preempt | no preempt] [[advertising]
interval seconds]
no vrrp vrid vlan_id
Syntax Definitions
vrid
vlan_id
enable
disable
on
off
priority
preempt
no preempt
seconds
OmniSwitch CLI Reference Guide
The virtual router ID, in the range from 1–255.
The VLAN on which the virtual router is configured. The VLAN must
already be created and available on the switch.
Enables the virtual router. A virtual router may only be enabled if an IP
address is configured for the virtual router.
Disables the virtual router. Cannot be combined on the same line with
other parameters.
Alternate syntax for enabling the virtual router.
Alternate syntax for disabling the virtual router.
The priority for this virtual router to become the master router. The
range is 1 (lowest priority) to 255 (highest priority). The priority should
be set to 255 only if this router is the actual owner of the virtual router's
IP address.
Specifies that a higher priority router may preempt a lower priority
master router.
Specifies that a higher priority router may not preempt a lower priority
master router.
The interval in seconds after which the master router will send VRRP
advertisements. The advertising interval must be same for all VRRP
routers configured with the same VRID. The valid range is 1–255
seconds.
March 2011
vrrp
page 16-3