Ip Rip Interface Ingress-Filter - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

RIP Commands

ip rip interface ingress-filter

Assigns an ingress route map filter to the specified RIP interface. Received route advertisements are
compared against ingress filters. When a prefix matches the corresponding filter, that prefix is accepted
on the interface. When a prefix does not match the filter, the prefix is dropped as if it was never received.
ip rip interface {interface_name} ingress-filter {filter_name}
Syntax Definitions
interface_name
filter_name
Defaults
By default, no such filter is associated with the RIP interface.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
One route-map filter is configurable in each direction (ingress/egress) for each RIP interface.
•
Configuring multiple filters in the same direction for a single RIP interface is not supported.
Examples
-> ip route-map ripfilter1 action permit
-> ip route-map ripfilter1 match ip-address 202.5.0.0/16 deny
-> ip rip interface vlan-100 Ingress-filter RipFilter1
Release History
Release 7.1.1; command was introduced.
Related Commands
ip rip interface egress-filter
show ip rip interface
MIB Objects
OmniSwitch CLI Reference Guide
The name of an existing RIP interface.
The name of an existing route-map filter.
Assigns an egress route map filter to a RIP interface.
Displays RIP interface status and configuration.
March 2011
ip rip interface ingress-filter
page 13-13