Ip Rip Interface Auth-Type - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip rip interface auth-type

ip rip interface auth-type
Configures the type of authentication that will be used for the RIP interface. By default, there is no authen-
tication used for RIP. However, you can configure a password for a RIP interface. To configure a pass-
word, you must first select the authentication type (simple or MD5), then configure a password.
ip rip interface {interface_name} auth-type {none | simple | md5}
Syntax Definitions
interface_name
none
simple
md5
Defaults
parameter
none | simple
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Regardless of which authentication type is used (simple or MD5), both switches on either end of a link
must share the same password.
Examples
-> ip rip interface rip-1 auth-type none
Release History
Release 7.1.1; command was introduced.
Related Commands
ip rip interface auth-key
MIB Objects
rip2IfConfTable
rip2IfConfAddress
rip2IfConfAuthType
page 13-20
The name of the interface.
No authentication will be used.
Simple authentication will be used.
MD5 authentication will be used.
default
none
Configures the text string that will be used as the password for the
RIP interface.
OmniSwitch CLI Reference Guide
RIP Commands
March 2011