Show Ipsec Policy - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IPsec commands

show ipsec policy

Displays information about the security policies.
show ipsec policy [name]
Syntax Definitions
name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the name parameter to display information about a specific security policy.
Examples
-> show ipsec policy
Name Source-> Destination
------------+--------------------------------+--------+----------+--------+--------
ftp-in-drop ::/0->2001:db8:3::13d
telnet-in-1 2001:db8::/48->2001:db8:1::24
telnet-out-1 2001:db8:1::24->2001:db8::/48
output definitions
Name
Source -> Destination
Protocol
Direction
Action
State
-> show ipsec policy telnet-out-1
Name = telnet-out-1
Source = 2001:db8:1::24
Destination = 2001:db8::/48
Protocol = TCP
Direction = out
Action = ipsec
State = active
Rules:
OmniSwitch CLI Reference Guide
The policy name.
The name of the security policy.
Indicates the source and destination of traffic covered by this policy.
Indicates the protocol traffic covered by this policy. The protocol name
(TCP) or protocol number (80) is displayed in this field.
Indicates whether the policy has been applied to the incoming or outgo-
ing traffic.
Indicates the action to be taken on the traffic covered by this policy.
Indicates the operational state of this policy.
March 2011
Protocol Direction
TCP in discard
TCP in
TCP out
show ipsec policy
Action State
active
ipsec active
ipsec active
page 12-13