Ip Rip Interface Recv-Version - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

RIP Commands

ip rip interface recv-version

Configures the receive option for a RIP interface. This defines the type(s) of RIP packets that the inter-
face will accept.
ip rip interface {interface_name} recv-version {v1 | v2 | both | none}
Syntax Definitions
interface_name
v1
v2
both
none
Defaults
parameter
v1 | v2 | both | none
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Using this command will override RIP default behavior.
•
Other devices must be able to interpret the information provided by this command or there will not be
proper routing information exchanged between the switch and other devices on the network.
Examples
-> ip rip interface rip-1 recv-version both
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the interface.
Only RIPv1 packets will be received by the interface.
Only RIPv2 packets will be received by the interface.
Both RIPv1 and RIPv2 packets will be received by the interface.
Interface ignores any RIP packets received.
default
both
March 2011
ip rip interface recv-version
page 13-11