Ip Bfd Multiplier - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip bfd multiplier

ip bfd multiplier
Configures the global BFD detection time multiplier. This command specifies a number that is used to
calculate the BFD detection time used in the asynchronous mode. The detection time value that is speci-
fied determines how long to wait before declaring that the BFD session is down.
ip bfd multiplier num
Syntax Definitions
num
Defaults
By default, the multiplier value is set to 3.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The global detection time multiplier is also configurable at the BFD interface level. Note that configur-
ing the global value with the ip bfd multiplier command does not override the value set for the inter-
face using the ip bfd interface multiplier command.
•
The global detection time multiplier serves as the default multiplier value for a BFD interface. The
default multiplier value is overridden when a specific value is configured for the interface.
Examples
-> ip bfd multiplier 5
Release History
Release 7.1.1; command was introduced.
Related Commands
ip bfd interface multiplier
show ip bfd
MIB Objects
alaBfdGlobalDetectMult
page 14-6
The detection time multiplier number. The valid range is 3–255.
Configures the detection time multiplier for a BFD interface.
Displays the BFD global status and general configuration parameters.
OmniSwitch CLI Reference Guide
BFD Commands
March 2011