Ip Bfd Interface Echo-Interval - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

BFD Commands

ip bfd interface echo-interval

Configures the echo time interval for the BFD interface. The echo function is available with the asynchro-
nous mode. Echo packets are transmitted to BFD peers to see if they loop back to the peer from which
they originated.
ip bfd interface if_name echo-interval echo_interval
Syntax Definitions
if_name
echo_interval
Defaults
parameter
echo_interval
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The global echo time interval serves as the default interval value for a BFD interface. The default inter-
val value is overridden when a specific value is configured for the interface.
•
Note that configuring the interface echo time interval using the ip bfd interface echo-interval
command does not change the global value configured with the ip bfd echo-interval command.
Examples
-> ip bfd interface bfd-vlan-101 echo-interval 500
Release History
Release 7.1.1; command was introduced.
Related Commands
ip bfd interface
ip bfd echo-interval
show ip bfd interfaces
show ip bfd sessions
MIB Objects
alaBfdIntfTable
alaBfdIntfReqMinEchoRxInterval
OmniSwitch CLI Reference Guide
The name of an existing IP interface.
The echo time interval, in milliseconds. The valid range is 100–999.
default
300 milliseconds
Creates a BFD interface.
Configures a global BFD echo time interval.
Displays the BFD interface configuration table.
Displays the BFD interface configuration table.
March 2011
ip bfd interface echo-interval
page 14-13