Ipv6 Rip Interface - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IPv6 Commands

ipv6 rip interface

Creates or deletes a RIPng interface.
ipv6 rip interface if_name
[no] ipv6 rip interface if_name
Syntax Definitions
if_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
By default, a RIPng interface is created in the enabled state.
•
Routing is enabled on a VLAN when you create a router port. However, to enable RIPng routing, you
must also configure and enable a RIPng routing interface on the VLAN's IP router port. For more
information on VLANs and router ports, see
•
RIPng will support a maximum of 20 interfaces.
Examples
-> ipv6 rip interface Test_Lab
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
IPv6 interface name.
Chapter 4, "VLAN Management
March 2011
ipv6 rip interface
Commands".
page 11-79