Show Ip Rip Interface - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

RIP Commands

show ip rip interface

Displays RIP interface status and configuration.
show ip rip interface [interface_name]
Syntax Definitions
interface_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Enter an IP address to view a specific interface. Enter the basic show ip rip interface command to show
status for all interfaces.
Examples
-> show ip rip interface rip-1
Interface IP Name
Interface IP Address
IP Interface Number (VLANId)
Interface Admin status
IP Interface Status
Interface Config AuthType
Interface Config AuthKey Length
Interface Config Send-Version
Interface Config Receive-Version
Interface Config Default Metric
Received Packets
Received Bad Packets
Received Bad Routes
Sent Updates
output definitions
Interface IP Name
Interface IP Address
IP Interface Number
Interface Admin Status
IP Interface Status
Interface Config AuthType
OmniSwitch CLI Reference Guide
The interface name.
= rip-1,
= 11.11.11.1
= 4,
= enabled,
= enabled,
= None,
= 0,
= v2,
= both,
= 1,
= 154,
= 0,
= 0,
= 8
The IP Interface name.
Interface IP address.
Interface VLAN ID number.
The RIP administrative status (enabled/disabled).
Interface status (enabled /disabled).
The type of authentication that will be used for the RIP interface (None
or Simple).
March 2011
show ip rip interface
page 13-31