Configuring Route Resolution (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 40: Configuring Options Fields
Option
Comment
Mark
Syslog

Configuring Route Resolution (NSM Procedure)

66
Function
Specifies the comment for the message
option.
Specifies the mark for the option.
Enables you to configure the generation
of system log messages for a particular
severity level and all higher levels.
You can configure a routing table to accept routes from specific routing tables to enable
the device to manage and route the traffic effectively between a source host and
destination host. You can configure a routing table to use specific import policies to
produce a route resolution table to resolve routes.
To configure a route resolution table in NSM:
In the navigation tree, select
1.
In the list, double-click the device to select it.
Devices
2.
Click the Configuration
3.
In the configuration tree, expand
4.
Select Resolution .
5.
Add or modify the parameters as specified in Table 41 on page 67.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
Enter the comment.
Enter the mark value or select from the
list.
1.
2. Select the severity levels for system
Device Manager > Devices
tab.
.
Routing Options
Expand the tree and select
Options
.
Syslog
log messages.
.
Copyright © 2010, Juniper Networks, Inc.