Toyota Celica 2005 Repair Manual page 912

IAT (12 sec. after engine start)
ECT (12 sec. after engine start)
TYPICAL MALFUNCTION THRESHOLDS
Detection criteria
TFT (transmission fluid temperature)
COMPONENT OPERATING RANGE
Parameter
TFT (transmission fluid temperature)
WIRING DIAGRAM
See page DI−706.
INSPECTION PROCEDURE
1 Check other DTCs output (in addition to DTC P0711)
PREPARATION:
(a) Warm up the engine.
(b) Turn the ignition switch off.
(c) Connect the OBD II scan tool or hand−held tester to the DLC3.
(d) Turn the ignition switch to the ON position.
(e) Push the "ON" button of the OBD II scan tool or the hand−held tester.
(f) Select the item "DIAGNOSIS/ENHANCED OBD II/DTC INFO/CURRENT CODES".
CHECK:
Read the DTCs using the OBD II scan tool or the hand−held tester.
RESULT:
Only "P0711" is output
"P0711" and other DTCs
HINT:
If any other codes besides "P0711" is output, perform the troubleshooting for those DTCs first.
A
2005 CELICA (RM1131U)
DIAGNOSTICS
Display (DTC output)
− AUTOMATIC TRANSAXLE (U240E)
−10°C (14°F) or more
−10°C (14°F) or more
Atmospheric temperature to approx. 130°C (266°F)
B Go to relevant DTC chart (See page DI−693).
911
−
−
Threshold
Less than 10°C (50°F)
Standard value
Proceed to
A
B
DI−711