Setting Header Index Mode; Setting Return To Cut Mode - MacDon M155 Unloading And Assembly Instructions

7.3.5 Setting Header Index Mode

Enabling header index mode in the cab display module (CDM) links the speed of the reel and the draper on draper headers
to the windrower's ground speed. It can be configured in the CDM by accessing the HEADER INDEX MODE sub-menu in the
WINDROWER SETUP menu.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
4. Press SELECT (D) until HEADER INDEX MODE? appears on
the upper line.
• REEL & CONVEYOR or REEL ONLY will appear on the
lower line.
5. Press left arrow (B) or right arrow (C) to set HEADER INDEX
mode. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.

7.3.6 Setting Return to Cut Mode

Enabling the return to cut feature in the cab display module (CDM) allows the Operator to make use of height and
(optionally) tilt position presets. The return to cut feature can be configured by accessing the RETURN TO CUT MODE sub-
menu in the WINDROWER SETUP menu.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
1. Turn the ignition key to the RUN position or start the engine.
262320
CAB DISPLAY MODULE
A
Figure 7.25: M155 CDM Programming Buttons Shown
A
Figure 7.26: M155 Header Index Mode Shown
215
WINDROWER SETUP?
CXXX
MXXX
NO/YES
HEADER INDEX MODE?
CXXX
MXXX
REEL & CONVEYOR
B
C
B
D
C
Revision A