6. Remove the temporary reel support (A).
7. Install the drive cover, refer to
page
210.
5.9.5 Replacing Reel Drive Motor
The reel drive motor does not require regular maintenance or servicing. If problems occur with the motor, remove it
and have it serviced at your MacDon Dealer.
Removing Reel Drive Motor
1. Loosen the drive chain, refer to
page
211.
2. Remove the drive sprocket, refer to
Sprocket, page
213.
3. Disconnect the hydraulic lines (A) at the motor (B). Cap
or plug open ports and lines.
NOTE:
Mark the hydraulic lines (A) and their locations in the
motor (B) to ensure correct reinstallation.
4. Remove four nuts and bolts (C) and remove the
motor (A). Retrieve the spacer (not shown) from
between the motor (B) and the motor mount
(if installed).
147725
MAINTENANCE AND SERVICING
Installing Drive Cover,
Loosening Drive Chain,
Removing Drive
217
Figure 5.215: Supporting Reel
Figure 5.216: Reel Motor and Hoses
Revision A