Adjusting Header Draper Tracking - MacDon D65 Operator's Manual

4. Lift deck, remove stand (B), and lower deck into
position. Remove pry bar (A).
5. Line-up deck supports (A) with bolts in deck.
6. Move deck towards cutterbar to engage deck supports.
7. Install nuts (B) and tighten.
8. Adjust draper tension. Refer to
Tension, page 165.

5.7.6 Adjusting Header Draper Tracking

Each draper deck has a fixed drive roller (A) and a spring-loaded idler roller (B) that can be aligned using the
adjuster rods so the draper tracks properly on the rollers.
CAUTION
To avoid personal injury, before servicing machine or opening drive covers, refer to
for Servicing, page 111.
147725
MAINTENANCE AND SERVICING
5.7.3 Adjusting Draper
170
Figure 5.104: Lifting the Deck
Figure 5.105: Deck Support
5.1 Preparing Machine
Revision A