Attaching Tow-Bar - MacDon D65 Operator's Manual

Attaching Tow-Bar

The tow-bar consists of two sections, which make storage and handling easier.
1. Unhook rubber strap (D) from cradle (A) on the right side of
the header.
2. Remove clevis pin (C) and detach the tube end from
support (B).
3. Replace clevis pin (C).
4. Lift the inner half of the tow-bar off the header and place it
near the left side of the header.
5. Unhook rubber strap (D) from cradle (A) on the left side of
the header.
6. Remove hitch pin (C) from support (B), and remove the
tow-bar.
7. Install rubber strap (D) on cradle (A).
214327
OPERATION
Figure 3.108: Tow-Bar Removal – Right Side
C
Figure 3.109: Tow-Bar Removal – Left Side
109
D
A
B
B
A
C
1004705
D
Revision B