Show Ip Pim Bsr-Router - Dell Z9500 Command Reference Manual

If the PIM DR flood is not disabled (default setting):
•
•

show ip pim bsr-router

View information on the Bootstrap router.
Z9500
Syntax
show ip pim [vrf vrf-name] bsr-router
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
Example
Dell#show ip pim bsr-router
PIMv2 Bootstrap information
This system is the Bootstrap Router (v2)
This system is a candidate BSR
length: 30
1390
Multicast traffic is transmitted on the egress port towards the PIM DR if the port
is not the incoming interface.
Multicast traffic for an unknown group is sent on the port towards the PIM DR.
When DR flooding is disabled, multicast traffic for an unknown group is
dropped.
EXEC
EXEC Privilege
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
BSR address: 7.7.7.7 (?)
BSR Priority: 0, Hash mask length: 30
Next bootstrap message in 00:00:08
Candidate BSR address: 7.7.7.7, priority: 0, hash mask
PIM-Sparse Mode (PIM-SM)