dummyhead
dummyhead
FUEL PUMP RELAY INSPECTION
Remove the fuel pump relay from the fuse/relay
junction box (page 10-6).
Connect the ohmmeter to the fuel pump relay terminal
C [1] and terminal D [2].
Connect the battery positive (+) cable to the fuel pump
relay terminal A [3] and battery negative (–) cable to
terminal B [4].
• When connecting the fuel pump relay terminals, do
not interchange the battery positive (+) cable and
battery negative (–) cable.
There should be continuity while the battery is
connected to the relay terminals, and there should be
no continuity while the battery is disconnected.
ELECTRIC PARTS CASE REMOVAL/
INSTALLATION
Remove the fuse/relay junction box (page 10-2).
Remove the DLC [1], tacho pulse 2P connector [2] and
interface 6P connector [3] from the electric parts case
[4].
Disconnect the switch panel wire harness 14P
connector [5], indicator wire harness 6P connector [6]
and neutral switch 2P connector [7].
Release the starter cable 1 (+) [1] from the wire harness
clip [2].
Remove the main wire harness from the two harness
band clips [3]
Remove the four bolt/washers (6 x 26 mm) [4], the five
harness band clips [5] and the electric parts case [6].
OTHER ELECTRICAL
[1]
[2]
[4]
[3]
[1] [2] [3]
[5]
[2]
[1]
[6]
[5]
[3]
[6]
[1]
[4]
[3]
[4]
[7]
[3]
[4]
[2]
10-7