Selectable Display Messages - NEC univerge SV9100 Programming Manual

Level:
SA
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display Messages. There
are 20 alphanumeric messages, with up to 24 characters. Use the following chart when programming
messages.
Table 2-7 Keys for Entering Names
Use this keypad
digit . . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0
Enter characters:


# # = Accepts an entry (only required if two letters on the same key are
needed – ex: TOM). Pressing
mode, use the right arrow soft key instead to accept and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the right.
2-280
Program 20 : System Option Setup
When you want to. . .
 
! " # $ % &
+ , - . / : ;
# again = Space. (In system programming

20-16 : Selectable Display Messages

Á À Â Ã Ç É Ê ì ó
' ( ) ô Õ ú ä ö ü

< = > ? π Σ

∞
¢ £
Ω
Program 20 : System Option Setup
Issue 4.0