Table of Contents
Advertisement
General Product Description
1.4.7 Extended Application Processor (AP) Port Capacity
The SOPHO 2000 IPS provides maximum 256 AP ports and it is independent of the 1020
ports for the Line/Trunk (LT), therefore, more AP cards such as T1/E1 digital link cards
can be used in the system.
1.4.8 Office Data Backup Enhancement
The office data of the SOPHO 2000 IPS is stored in Flash ROM; therefore the backup
period is extended compared to systems using RAM with battery.
1.4.9 Various Installation Methods
To meet the specific needs of the customer's environment, the SOPHO 2000 IPS provides
the following installation methods:
-
Floor Standing Installation
-
Wall-mounting Installation
-
IEC standard 19 inch Rack-mounting Installation
1.4.10 Station to Station Connection
For DtermIP to DtermIP connection (Peer to Peer connection), the voice data is
transmitted and received directly between DtermIPs on the LAN. For Dterm Legacy
terminal connection, the IPPAD card and VCT card are required to transmit and receive
the voice data. These cards are used to control and convert the voice data. The MP card in
either of the connections above manages the control signals.
1.4.11 CCIS Connection
DtermIP to DtermIP connection (Peer to Peer connection) via CCIS is available only
when the destination office is SOPHO 2000 IPS or SV7000.
The DtermIP connection via CCIS is Peer to Peer to the ISG (IP interface card) in the
iS3000.
The system provides only Point to Multipoint connection.
1.4.12 Maintenance
MATWorX IPS is used as the maintenance program for the SOPHO 2000 IPS. Direct
connection (RS-232C), Modem connection and LAN (TCP/IP) connections are available
to connect to the MAT (Maintenance Administration Terminal).
1.4.13 Dual MP System
The system complies with dual control system on Main Processor.
Note: Since the system employs Cold Standby processing in MP changeover, the calls in
progress are terminated as a result of the MP changeover. Also, during the MP
changeover, the call originating/receiving and service feature access are not
effective. (It takes about 30 to 60 seconds to complete the MP changeover.)
1.4.14 Remote PIM over IP with Survivability
The SOPHO 2000 IPS can have a PIM installed at a remote site through an IP network.
At the main site, the SOPHO 2000 IPS/IPS DM is installed and SOPHO 2000 IPS /IPS
DMR are installed at the remote site. The main site controls call processing and service
feature access for station users located at both the main and remote sites. When the
NEC Philips Unified Solutions
Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
Sopho 2000IPS
UPD
© NEC Philips Unified Solutions, 2006. All right reserved.
Release 12.2, August 2006
21 of 259
Advertisement
Table of Contents
