Installation; Gpz-8Dlcb Daughter Board Cable Connection - NEC Univerge SV9100 Hardware Manual

Issue 1.2
4 - 38
4.2.2

Installation

The GPZ-8DLCB is installed on the GCD-8DLCA. To install:
1. Connect the GPZ-8DLCB to the CN2 connector on the
GCD-8DLCA blade. Refer to
16DLCA/ Blade on page 4-32
on the blade.
2. Install the GCD-8DLCA into a slot.
3. Each CNx01 connector (CN101, CN201, CN301, CN401) is
used to connect up to four digital extensions.
4.2.3

GPZ-8DLCB Daughter Board Cable Connection

The GPZ-8DLCB blade has connections for CN301 and CN401
Refer to for connector locations.
The following tables show the cable connections of the two RJ-61
connectors on the GPZ-8DLCB.
Figure 4-9 GCD-8DLCA/GCD-
for the location of the connectors
Table 4-17GPZ-8DLCB CN301 Connection
RJ-61 Cable Connector
CN301 (ports 9~12)
Pin No.
1
2
3
4
5
6
7
8
Installing the SV9100 Blades
UNIVERGE SV9100
Connection
(T4) Tip for port 12
(T3) Tip for port 11
(T2) Tip for port 10
(R1) Ring for port 9
(T1) Tip for port 9
(R2) Ring for port 10
(R3) Ring for port 11
(R4) Ring for port 12