Job Procedures - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

DI0A-4

Job procedures

1. Always keep the workshop and lift clean (especially, from dust).
2. Always keep the tools clean (from oil or foreign materials).
3. Wear a clean vinyl apron to prevent the fuzz, dust and foreign materials from getting into fuel system. Wash
your hands and do not wear working gloves.
4. Follow the below procedures before starting service works for fuel system.
Visually check the leaks and vehicle appearance on the wiring harnesses
Locate the fault. If the cause is from fuel system (from priming pump to
injector, including return line), follow the step 1 through step 3 above.
5. If the problem is from HP pump, fuel supply line or injector, prepare the clean special tools and sealing caps
to perform the diagnosis for DI engine fuel system in "DIAGNOSIS" section in this manual. At this point,
thoroughly clean the related area in engine compartment.
Notice
Clean the engine compartment before starting service works.
Tool kit for high pressure line
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
Carefully listen the symptoms and problems from customer.
and connectors in engine compartment.
Perform the diagnosis proceee with Scan-i
(refer to "DIAGNOSIS" section in this manual).
Took kit for low pressure line Removal tool box and cap kits
GENERAL INFORMATION
DI ENG SM - 2004.4