During Service Work For Electric Devices - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

During Service Work for Electric
Devices
Notice
Be careful not to modify or alter electrical system and
electrical device. Or there can be vehicle fire or serious
damage.
1. Be sure to disconnect battery negative (-) terminal during
every service work. Before disconnecting battery negative
(-) terminal, turn off ignition key.
2. Replace with specified capacity of fuse if there is bad,
blown or short circuited fuse. If use electrical wire or steel
wire other than fuse, there can be damages on the various
electrical systems. If replaced with over-capacity fuse,
there can be damages on the related electrical device
and fire.
3. Every wire on the vehicle should be fastened securely
not to be loosened with fixing clip.
4. If wires go through edges, protect them with tape or other
materials not to be damaged.
5. Carefully install the wires not to be damaged during
installation/removal of parts due to interference.
6. Be careful not to throw or drop each sensor or relay.
7. Securely connect each connector until hear a "click"
sound.
GENERAL INFORMATION
DI ENG SM - 2004.4
DI0A-35
Y220_0A031
Y220_0A032
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN