SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 33

DI0A-34
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
8. Never reuse cotter pin, gasket, O-ring, oil seal, lock
washer and self-locking nut. Replace them with new.
If reused, normal functions cannot be maintained.
9. Align the disassembled parts in clean according to
disassembling order and group for easy assembling.
10. According to installing positions, the bolts and nuts have
different hardness and design. So be careful not to mix
removed bolts and nuts each other and align them
according installing positions.
11. To inspect and assemble, clean the parts.
12. Securely clean the parts that related with oil not to be
affected by viscosity of oil.
Y220_0A029
13. Coat oil or grease on the driving and sliding surfaces
before installing parts.
14. Use sealer or gasket to prevent leakage if necessary.
15. Damaged or not, never reuse removed gasket. Replace
with new and cautious on installing directions.
16. Tighten every bolt and nut with specified torque.
17. When service work is completed, check finally whether
the work is performed properly or the problem is solved.
18. If work on the fuel line between priming pump and injector
(including return line), be sure to cover the removed parts
with cap and be careful not to expose the connecting
passage and removed parts to external foreign materials
Y220_0A030
or dust. (Refer to cleanness.)
19. If remove high pressure fuel supply pipe between HP pump
and fuel rail and high pressure fuel pipe between fuel rail
and each injector, be sure to replace them with new.
GENERAL INFORMATION
DI ENG SM - 2004.4