SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 52

Measuring Procedure
Notice
• Disconnect the fuel rail pressure sensor connector to cut off the fuel injection.
• Discharge the combustion residues in the cylinders before testing the compression pressure.
• Apply the parking brake before cranking the engine.
1. Warm the engine up to normal operating temperature
(80°C).
2. Disconnect the fuel rail pressure sensor connector to
cut off the fuel injection.
3. Place the diagram sheet to compression pressure tester.
4. Remove the glow plugs and install the compression
pressure tester into the plug hole.
Tightening torque (Tester)
5. Crank the engine for approx. 10 seconds by using the
start motor.
6. Record the test result and measure the compression
pressure of other cylinders with same manner.
7. If the measured value is not within the specifications,
perform the cylinder pressure leakage test.
ENGINE ASSEMBLY
DI ENG SM - 2004.4
15 Nm
DI01-17
Y220_01006
Y220_01007
Y220_01008
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN