Advertisement
no radius-source-ip source
•
source — Specifies the source IP address.
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the source IP address used for communication with RADIUS
servers to 10.1.1.1.
console(config)# radius-server source-ip 10.1.1.1
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval for which the
Ethernet Switch Module waits for a server host to reply. To restore the default, use the no form of
this command.
Syntax
radius-server timeout timeout
no radius-server timeout
timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
•
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
200
Radius Commands
Advertisement
