Radius-Server Deadtime - Dell Networking 7048 Reference Manual

User Guidelines
This command does not change the address in the IP header for the request
sent to the RADIUS server. It only changes the address sent to the RADIUS
server inside the RADIUS packet.
Example
The following example sets the NAS IP address in RADIUS attribute 4 to
192.168.10.22.
console(config)#radius-server attribute 4
192.168.10.22

radius-server deadtime

Use the radius-server deadtime command in Global Configuration mode to
configure the minimum amount of time to wait before attempting to
recontact an unresponsive RADIUS server. If a RADIUS server is currently
active and responsive, that server will be used until it no longer responds.
RADIUS servers whose deadtime interval has not expired are skipped when
searching for a new RADIUS server to contact. To set the deadtime to 0, use
the no form of this command.
Syntax
radius-server deadtime
no radius-server deadtime
deadtime — Length of time in minutes, for which a Radius server is
•
skipped over by transaction requests. (Range: 0–2000 minutes). Deadtime
is used to mark an unavailable Radius server as dead until this user-
configured time expires. Deadtime is configurable on a Radius server basis.
Default Configuration
The default dead time is 0 minutes.
Command Mode
Global Configuration mode
736
RADIUS Commands
deadtime