Lift Shaft Front Tray Cable Pulley; Preparing To Remove The Front Tray Cables - Xerox WorkCentre 5222 Service Manual

Figure 7 Lift Shaft front Tray Cable Pulley
4. Remove the E-Rings, Wire Guides, and Pulleys from the front of the HCF Tray.
1. Remove (2) E-Rings, (2) Wire Guides, and (2) Pulleys.
Launch Version
WorkCentre 5225, 5230
1
Remove E-Rings (2), Wire
Guides (2), and Pulleys (2)
Figure 8 Preparing to remove the front Tray Cables
(Figure 8) 2. When both sections of the cable are slack, disengage the Lift Shaft from the frame and
slide the Tray Cable Pulley to the front of the Lift Shaft to release the Rear Lift Cable ends
that are trapped in the pocket underneath the Tray Cable Pulley.
February, 2008
4-43
(Figure 9)
Repairs and Adjustments
REP 7.3.4