Port Selection For Management Interface Connection - Hitachi Compute Blade 2000 User Manual

The default IP addresses at shipment are as follows:
Module
Management Module
Server Basic/
Blade LPAR
manager
Common
Interface
LPAR
manager
Dedicated
Interface
Switch Slot 0
Module
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
Port selection for management
interface connection
The Compute Blade 2000 is equipped with ports MGMT0 and MGMT1 for
connecting to the management network. For each module, you can choose which of
these two ports to use when connecting to the management interfaces. This allows
the system to be configured for different purposes, as in these examples:
 Use MGMT0 to connect to the management module, and MGMT1 to connect to
the server blade and switch module. This allows a clear separation of the
network based on the management targets.
 Use MGMT0 to connect to server blades 0 to 3, and MGMT1 to connect to
server blades 4 to 7, thereby distributing the network load.
You can change the port settings from the management module's serial console or
from the system Web console. For the procedure, see "Command List" or "List of
System Web Console Features" in Chapter 6.
IP address Subnet mask
192.168.0.1 255.255.255.0
Not set.
Not set.
192.168.253.35 255.255.255.240
192.168.253.36 255.255.255.240
192.168.253.37 255.255.255.240
192.168.253.38 255.255.255.240
192.168.253.39 255.255.255.240
192.168.253.40 255.255.255.240
1504
Remarks