Setting The Ip Address - Hitachi Compute Blade 2000 User Manual

The default connection methods at shipment are as follows:
Module
Management Module
Server Blade
Switch Module

Setting the IP address

The IP address of each module's management interface can be set as follows:
Module
Management Module
Server Basic/
Blade LPAR
manager
Shared
Interface
LPAR
manager
Dedicated
Interface
Switch Module
If you choose to connect to the switch module using the management module
exclusive method, you must set the switch module's IP addresses in advance, as
listed in the following table. If the IP address differs from these values, the switch
module console will not be accessible from the management module.
Switch module slot
Slot 0
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
(*) Value when the internal network setting is the factory default (192.168.253.0). If the
internal network IP address has been changed, change the upper three bytes to the
internal network setting.
The management module communicates with switch
modules using IP address 192.168.253.33.
Connection Method
Via MGMT0
Via MGMT0 The IP address is not preset. The
server blade cannot be accessed
until its IP address is set.
Management module The IP address for connection using
exclusive the management module exclusive
method is preset in the switch
module.
Connection Method
Management For details, see "Command List " or
module's serial "List of System Web Console
console or the system Features" in Chapter 6.
Web console
Management For details, see " Command List " or
module's serial "List of System Web Console
console or the system Features" in Chapter 6.
Web console
LPAR manager For details, see "Chapter 12: Logical
console partitioning manager".
Switch module For details, see your switch module
console manual.
IP address (*)
192.168.253.35 255.255.255.240
192.168.253.36 255.255.255.240
192.168.253.37 255.255.255.240
192.168.253.38 255.255.255.240
192.168.253.39 255.255.255.240
192.168.253.40 255.255.255.240
1503
Remarks
Remarks
Subnet mask