Hitachi Compute Blade 2000 User Manual page 1578

Item
Emulex 10 Gb CNA setting Internet small computer system interface (iSCSI)
PR command setting
HA command setting
*1 See WWN in the Compute Blade
*2 See MAC address in the Compute Blade
*3 See RTC time synchronization at N+M cold standby
*4 Only items described in the EFI setup menu of the server blade Web console are
taken over. See "EFI setting screen" for EFI setup menu of the server blade Web
console.
*5 With Emulex 8 Gb 2-port Fibre-channel adapter or Emulex 8 Gb 2-port Fibre-
channel mezzanine card,
items in the setup menu are taken over.
*6 You need to configure the same setting for MultiChannel Support and for
Personality to the active and standby partitions.
Disable DHCP for iSCSI settings.
Set a unique IP Address for iSCSI Initiator.
Connect to iSCSI Target correctly: Connected.
Up to four iSCSI Traget sessions are available per port.
Do not enter any Default Gateway for iSCSI Initiator: Set as 0. 0. 0. 0.
See product instructions for the 10 Gb converged network for details of each item.
When the active partition recovers N+M, the

information taken over to the standby partition is
restored to the active partition. So, the active partition
is recovered to the condition before N+M failover. But
the standby partition still has the information taken
over from the active partition and is not recovered to
the condition before N+M failover. Only WWN in
standby partition is recovered to the condition before
N+M failover.
When Emulex 10 Gb CNA is used with iSCSI for

Personality, information on the IP address, Subnet
Mask, and session will be removed from the active
partition at N+M failover and from the standby partition
at N+M restore.
Description
Bandwidth
(with MultiChannel Support : Enabled)
Logical Port VLAN ID
(LPVID)
(with MultiChannel Support : Enabled)
setting (with iSCSI for Personality)
FCoE setting (with FCoE for Personality)
Power control cooperation setting
N+M cold standby aid function setting
High availability (HA) monitor system name
HA monitor port number
HA monitor setting for N+M cold standby aid
function
HA monitor setting for cluster management
2000.
2000.
or Emulex 16 Gb 2-port fibre channel adapter,
1527
Note
failover..
all