Smart Configure - Hitachi Compute Blade 2000 User Manual

Smart Configure

Overview of Smart Configure
The following features use Smart Configure. Smart Configure for each feature is
outlined below. If Smart Configure is enabled, the Fibre-channel board 10 Gb CNA
adapter or 10 Gb CNA board uses an Optional Physical WWN.
 N+M cold standby
For N+M cold standby, setting information for the active partition is obtained in
advance and stored in the management module.
When switching N+M, the setting information for the active partition stored in the
management module is set for the standby partition.
In addition, the Optional Physical WWNs assigned to the Fibre-channel board
10 Gb CNA adapter or 10 Gb CNA board in the active and standby partitions
are swapped and re-assigned to each Fibre-channel board 10 Gb CNA adapter,
or 10 Gb CNA board.
Smart Configure is performed when the setting information is obtained or set,
and when the Optional Physical WWNs are set.
For details of N+M cold standby, see
For details of Optional Physical WWNs used in N+M cold standby, see
cold standby.
Do not operate the server blade during Smart Configure. If you do, Smart Configure may
fail.
After Smart Configure, the partition cannot start by

Wake On LAN.
Performing Smart Configure causes SAN boot to be

automatically assigned the lowest priority in the basic
input/output system (BIOS) boot priority setting.
N+M cold standby.
NOTICE
1518
N+M