Transfer To Basic Environment From Lpar Manager Environment; Ipv6 Setting For Lp Ip Addresses - Hitachi CB 520H A1 User Manual

Transfer to Basic environment from LPAR manager environment

The following table shows the setting and checking items when LPAR
manager environment is transferred to Basic environment.
Guest OS
Server blade
Storage
Notes:
1 For details, see the Hitachi Compute Blade 500 series Server Blade Setup Guide.
.

IPv6 Setting for LP IP Addresses

You must set at least either an IPv4 address or an IPv6 address for LPAR
managers. Note that you can set both an IPv4 address and an IPv6 address
for LPAR managers.
• When you desire to allow an LPAR manager to communicate with the
management module in IPv6, you must set an IPv6 address for the LPAR
manager and the management module in advance.
• Set an LP IP address in an internet protocol in which you desire to allow
management server to communicate with LPAR managers. You can also
set two LP IP addresses in both IPv4 and IPv6 for an LPAR manager.
Firmware combinations
Server blade
CB 520H B3
CB 520H B4
CB 520X B1
CB 520X B2
CB 520X B3
2-18
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Table 2-9 Setting/checking item
Item
IP address deletion (only for
windows)
-
-
EFI setting
Basic mode setting
-
Server blade
firmware
08-35 or later
10-03 or later
07-34 or later
09-17 or later
11-07 or later
System Operation
Setting/checking item
Before transfer
1
1
Management Module
firmware
A0260 or later
A0305 or later
A0260 or later
A0270 or later
A0320 or later
After transfer
IP address setting
(only for windows)
Driver installation
Teaming/Bonding
configuration
-
-
WWPN/WWNN setting
LPAR manager
firmware
02-25 or later
02-50 or later
02-25 or later
02-27 or later
02-56 or later