During Service Work For Electric Devices - SSANGYONG KYRON 2010.01 Manual

01-36
0000-00

14. DURING SERVICE WORK FOR ELECTRIC DEVICES

- Be careful not to modify or alter electrical system and electrical device.
Or there can be vehicle fire or serious damage.
1. Be sure to disconnect battery negative (-) terminal during every service work. Before
disconnecting battery negative (-) terminal, turn off ignition key.
2. Replace with specified capacity of fuse if there is bad, blown or short circuited fuse. If use
electrical wire or steel wire other than fuse, there can be damages on the various electrical
systems. If replaced with over-capacity fuse, there can be damages on the related electrical
device and fire.
3. Every wire on the vehicle should be fastened securely not to be loosened with fixing clip.
4. If wires go through edges, protect them with tape or other materials not to be damaged.
5. Carefully install the wires not to be damaged during installation/removal of parts due to
interference.
6. Be careful not to throw or drop each sensor or relay.
7. Securely connect each connector until hear a "click" sound.
1) Lifting Positions
▶ 4-post lift
As illustrated, position the vehicle on the 4-post lift securely and block the front and rear of each
tire not to move during working.
- During lifting, be sure to check whether vehicle is empty.
Board-on lift connection device installed in front of vehicle should be positioned in front
·
of sill locating under the front door.
Install lift connecting device on the edge of front and rear of board-on lift.
·
Be sure to use attachment during lifting to prevent the lift from contacting with body
·
floor.
While lifting the vehicle, widen the lift floor as far as possible to stabilize between
·
vehicle front and rear.
When fixing the lift floor, be careful not to contact with brake tube and fuel lines.
▶ Safety jack and safety stand
If lift up the vehicle with safety jack and stand, should be more careful during works.
Never be under the vehicle if supported with only jack. If have to be under the vehicle,
·
be sure to use safety block.
Use wheel block in front and rear of every wheel.
·
ENGINE GENERAL
undefined