Ip Helper Boot-Up Enable - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

DHCP Relay Commands

ip helper boot-up enable

Specifies the type of packet to broadcast (BootP or DHCP) when automatic IP address configuration is

enabled for the switch.

Note. Automatic IP address configuration only supports the assignment of a permanent IP address to the

switch. Make sure that the DHCP server is configured with such an address before using this feature.

ip helper boot-up enable {BOOTP | DHCP}

Syntax Definitions

BOOTP | DHCP

Platforms Supported

OmniSwitch 6400, 6850,6850E, 6855, 9000E

Usage Guidelines

This command is only valid if automatic IP address configuration is already enabled for the switch.

-> ip helper boot-up enable DHCP

-> ip helper boot-up enable BOOTP

Release History

Release 6.1; command was introduced.

Release 6.4.3; command deprecated; use

Related Commands

ip helper boot-up

iphelperStatTable

iphelperBootupPacketOption

OmniSwitch CLI Reference Guide

Broadcasts a BOOTP formatted request packet.

Broadcasts a DHCP formatted request packet.

ip interface

dhcp-client.

Enables or disables automatic IP configuration for the switch.