Chevrolet 10 Series 1970 Service Manual page 98

BODY IB -20
F ig . 5 2 —Side Rear D oor Rear Remote Rod C lip Removal
5. P u ll downward on run and forw ard .
6. R em ove stationary glass with rubber s e a l attached,
and rem o ve run by pulling through a glass opening,
i f n ecessa ry.
7. R e v e rs e above procedu res to install.
F ig . 5 3 —Side Rear D oor Front Remote & Rod Removal
REAR W IN D O W WEATHERSTRIP
Panel and Suburban Trucks
Replacement
1. Using a pointed tool, r a is e one end of the w eath er­
strip reta in er until it is fa r enough out to take hold
of by hand. Then pull re ta in er out of its channel a ll
around the window.
2. From inside the cab, c a refu lly push the window glass
out through the re a r of the opening.
NOTE: The w eath erstrip may rem ain in the
window opening during rem o va l of glass.
rem ove w eatherstrip, m e re ly pull it off the edges
of the door panels. On installation of new weath­
e rs trip , clean opening
in sta ll with butt ends (lig h tly coated with weath­
e rs trip adhesive) at top center of opening.
3. Inspect the inner and outer flanges making sure they
a re true and that there are no ir re g u la ritie s around
the window opening.
corrected .
4. A ssem b le the w eath erstrip to the opening making
su re the outer channel of w eath erstrip is fir m ly
seated on the edges
opening.
5. Start one end of the glass into its
w eatherstrip. Using a pointed tool, follo w
T o
edge thoroughly, then
Any ir re g u la r itie s must be
of the panel a ll around the
channel in the
around
CHEVROLET TRUCK SERVICE MANUAL