BODY IB-36
F ig . 8 9 —Engine Access and Head Prop.
Gas Tank
1. Gas tank f i ll e r spout is located in a rece s s e d box in
left side at the re a r.
2. T o rem o ve gas gauge disconnect gas line, gas tank
fill e r spout, loosen gas tank hanger strap and drop
tank to ground.
V o ltage Regulator & H ea d lam p Relay
R em ove plate on bulkhead panel at front side o f right
hand slidin g door to gain a c c ess to voltage regu lator and
headlamp relay.
H eater
1. Hose w ire connections are a ccessib le through door
in outer cowl panel (fig . 89).
Horn
1. Horn w ire connections
outer cowl panel (fig . 89).
Engine Housing
1. R elea se catch, open engine box lid and lock hinge
a rm in open position.
a ccessib le through door in
2. Rem ove a c c e le ra to r pedal by taking out 2 cap screw s.
3. Rem ove m etal screw s around bottom of box, on v e r
tic a l sides at right re a r co rn er and le ft front corn er.
4. Rem ove box.
5. R e v e rs e procedu re to install.
W indshield W ipers
1. To s e rv ic e windshield w iper m otor rem ove inspec
tion plate (B ) in center of fron t end header panel
above windshield.
2. P iv o t assem blies s e rv ic e through openings on each
side of w iper m otor.
3. W iper switch is mounted in front end header a c
cessib le through left side opening.
4. C ircu it b rea k er fo r w ip er m otor is located on f i r e
w all d ire c tly above clutch pedal.
W indshield Wipers Adjustment
1. To adjust position of windshield w iper arm s have
them in park position. M ark this position on glass
with grease pencil.
2. R em ove the holding nut and lock washer fro m the
end of d rive shaft.
3. L ift off w ip er arm and knurled d riv e r. In m ost cases,
the knurled d riv e r
rem ains inside the w ip er arm .
Tap on arm ligh tly to rem ove the d riv e r and place
it back on w iper d rive shaft.
4. Position the arm above or below the m ark on wind
shield as desired, rep la ce lock washer and tighten
holding nut.
COMPLETE DRIVER'S W IN D O W
Installation
1. A ssem ble w eath erstrip rubber to the opening with
w eath erstrip reta in er groove to inside of body mak
ing sure the outer channel of w eath erstrip is fir m ly
seated on edge of door panel all around the opening.
Watch this ca refu lly on the co rn er radius. It is im
portant to start the rubber at the top at the point
F ig . 9 0 —D rivers W in d o w W e a th e rs trip
CHEVROLET TRUCK SERVICE MANUAL