Chevrolet 10 Series 1970 Service Manual page 111

SEATS
D river Seats
Both the standard seat and the optional d r iv e r ' s bucket
seat mount as shown in F igu re 81. A ll attaching screw s
must be torqued to 18 ft. lbs.
Front Passenger Seats
The optional au xiliary seat (fig . 82) and the optional
passen ger bucket seat (fig . 83) are mounted d ifferen tly
due to mounting bracket design d ifferen ces. A ll screw s
and nuts except the seat guide nut and bumper retaining
scrw s must be torqued to 18 ft. lbs. The seat guide nut
must be torqued to 25 ft. lbs. and the bumper retaining
sc re w must be torqued to 30 in. lbs.
Rear Seat
The optional re a r seat is shown in F igu re 84.
NOTE: A fte r rem ovin g the r e a r seat, rein sta ll
the bolts into the anchor nuts to seal the openings
fro m d irt and fo re ig n m atter. When rein stallin g
the seat, torque all hold-down bolts to 50 ft. lbs.
The re a r seat option also includes two seat belts and a
rubber re a r com partm ent flo o r mat. If rem ovin g the r e a r
seat te m p o ra rily —to haul cargo, fo r instance—it is not
n ecessary to rem ove the seat b elts fro m th eir anchor­
ages as they attach to the r e a r seat support.
REAR COMPARTMENT FLOOR M A T
Removal and Installation
1. L o w e r ta il gate.
2. Rem ove the spare tir e
3. R em ove the re a r seat.
and its mounting bracket.
F ig . 8 5 —Body M o u n t N o . 2
4. R em ove the fron t and re a r flo o r mat scuff plates.
5. R em ove the flo o r mat.
6. R e v e rs e Steps 1-5 to re in sta ll the flo o r mat.
BODY A N D PICK-UP BOX M O U N T IN G
NOTE: R e fe r to the section on Conventional
M odels fo r Body Mount #1. Mounts two, three,
four, and fiv e are as shown in Figure 85 and 86.
BODY IB-33
i
CHEVROLET TRUCK SERVICE MANUAL