Chevrolet 10 Series 1970 Service Manual page 561

F ig . 2 1 — Running Board and Braces (S ee i l l . for S eries)
4. Disconnect b attery and rem ove (righ t side only) or
rem ove s k irt rein forcem en t at steerin g column (le ft
s k irt only) (F ig . 18).
5. R em ove 2 top re a r fender bolts and shims.
6. R em ove bolt and shims at bottom of fender.
7. R em ove bolt and sh im (s) attaching sk irt to s ill ex­
tension.
8. R em ove 4 screw s attaching head light door to fender
and g r ille .
9. R em ove screw s attaching gusset to radiator support.
10. R em ove 3 screw s attaching sk irt to radiator support.
11. R em ove 2 sc rew s s e c u r i n g
support.
12. R em ove 4 s cre w s secu ring fen der to g r ille .
13. L ift fen d er and sk irt assem bly fro m truck.
FRONT FENDER A N D SURGE
TA N K ACCESS DOOR
Each fron t fender is retained with attaching screw s,
nuts and lock washers as shown in Figu re 22. The handle
attaches to the bottom at the re a r of the fender with ex ­
tern a l tooth w ashers, bolts and nuts. Tape is used b efore
installation.
Installation
FRONT FENDER SKIRT
Replacement
and rotate o v e r tire . R e v e rs e procedure to install.
FENDER SKIRT
4 0 -6 0 Series
Removal
2. Underneath the sk irt rem ove 2 screw s at top attached
4. R em ove 3 screw s at fron t of sk irt attached to fender.
6. Rem ove
7. Underneath the skirt, inboard, rem ove a la rg e bolt
8. Under the hood rem ove 2 screw s attaching sk irt r e ­
9. Rotate
Installation
of
n ecessary.
R U N N IN G BOARD A N D FENDER EXTENSION
4 0 , 5 0 and 6 0 Series (Except F /F C ow l and
School Bus)
fen der to radiator
OTHER R U N N IN G BOARDS
TILT
CABS
and a stud as shown.
ENGINE SPLASH SHIELD
Refer to Figure 23
Removal and Installation
1. Replace fen der and sk irt assem bly.
2. Install bolts loosely.
3. Install shim s and secure a ll parts in re v e r s e o rd e r
of rem oval.
4. Tighten shimmed bolts.
T o rep lace the sk irt alone, rem ove requ ired screw s
1. Turn steerin g wheel so tir e fron t is inboard.
to fender.
3. R em ove 3 screw s attaching sk irt to lo w e r fender
extension.
5. Rem ove 6 screw s holding sk irt to fen der opening
flange.
screw attaching sk irt to radiator g r ille .
fastened through the fender skirt to the cow l exten­
sion. Note shim and record .
inforcem ent to skirt.
sk irt outward
rearw ard.
R einstall in r e v e r s e o rd e r of rem oval. Note condition
tape sealin g of fen der
1. R em ove bolt fr o m inside door opening attached to
lo w er extension.
2. Rem ove bolts fro m under front of running board to
extension bottom.
3. R em ove 3 bolts fastening sk irt to flange of lo w er
extension.
4. P u ll lo w er fen der extension downward then out.
Refer to Illustrations
The surge tank a ccess door is retained with screw s
1. T ilt the cab to expose engine area.
CHASSIS SHEET METAL 11-11
over tir e , then rem ove
sk irt flange. Replace if
CHEVROLET TRUCK SERVICE MANUAL