Chevrolet 10 Series 1970 Service Manual page 179

F ig . 3 —Rem oving C o n tro l Arm S pring C lam p B olt
(Series C -P 1 0 and C 20)
during reassem b ly to assure p rop er retention of
these parts.
(R e fe r to Figure 5)
1. P ositio n bushed end o f control arm in pivot yoke be-
F ig . 4 —C o n tro l Arm Bushing R eplacem ent
(Series C -P 1 0 and C 20)
tween tunnel and fra m e, align holes with d rift and
in sert
2. Position clamp inside spring as shown in Figu re 6
so that it seats fr e e ly on spring end without any
hang-up. R aise control arm to the spring then pass
bolt, with flat w asher installed, up through control
arm and clamp. Install lock washer and nut. Torque
to specification s.
3. P la ce arm adjacent to axle. Pass
and through holes in arm .
4. P la ce shock absorber bracket on ends o f " U " bolt,
install nuts and torque to specification s.
5. Put full weight o f unloaded veh icle on the front and
J-7079-2
REAR SUSPENSION AND DRIVE LINE 4-3
F ig . 5 —C o n tro l Arm and S pring D e ta ils
(Series C -P 1 0 and C20)
p ivot bolt. P la ce nut on bolt fin ger tight.
F iq . 6 —S prinq C lam p In s ta lla tio n (Series C -
P10 and C 20)
CHEVROLET TRUCK SERVICE MANUAL
bolt o v e r axle