Chevrolet 10 Series 1970 Service Manual page 135

Installation
1. Thoroughly clean inside of glass channels to rem ove
old glazin g rubber,
2. P o sitio n new glazing rubber (soapstone side away
fro m glass) around edge of glass.
glazin g rubber into lo w e r channel, then p ress upper
channel o v e r top of glass.
fir m ly seated, then in stall two sm all screw s which
attach channels together.
3. If n ecessary, trim glazin g rubber at ends of channels
and along sides of channel each side of glass as
requ ired , seal cracks at latch bracket.
4. In sert pivot stud of vent lo w e r channel into hole of
vent fram e. Through sm all access hole at top of
door, in stall vent upper pivot screw . In stall three
screw s which attach bracket of vent channel to glass
d ivision channel just below vent latch.
5. In stall sp ecia l flat w asher, nylon fric tio n bushing,
and fric tio n clam p on vent lo w e r channel pivot shaft.
NOTE: Make sure
w asher is positioned p ro p e rly to act as a stop
of vent when it is in fu ll open position. Attach
fric tio n clam p to vent lo w e r fra m e with screw .
Tighten sc re w to obtain two to four pounds torque
while m oving vent window fro m
to a fu ll-op en position.
pull type spring sca le positioned at re a r edge
of glass*
6. In stall access panel to inner side of door.
DOOR GLASS RUN CHANNEL REPLACEMENT
1. Rem ove door window as explained p reviou sly under
" D o o r Window Glass R eplacem ent."
2. P u ll down on end of run channel at vent window, then
using a fla t blade s c r e w d r iv e r between channel and
door, detach channel retaining clips.
3. Make sure clip is detached at bottom of channel,
pull channel fro m door fra m in g and run channel
reta in er near bottom of door.
4. Install run channel into door fram in g and channel
F ig . 133— Door W e a th e rs trip In sta lle d
rust, or other fo re ig n m atter,
P r e s s glass with
Make sure channels are
that tab on sp ecia l fla t
a ten degree
Use eith er a push or
INSTALLING GLASS IN SEAL
G LA S S —— fcj
a
SEAL
w
PANEL
T Y P I C A L
F ig . 134—In s e rt-T y p e Seat
F ig . 135—D riv e r's Seat Assem bly
CHEVROLET TRUCK SERVICE MANUAL
BODY IB-57
INSERT