SCRIBE HORIZONTAL LINE
2. In sert a 5/16-inch hex wrench into head of s trik e r
bolt, then turn bolt cou nterclockw ise fro m plate in
cab p illa r.
3. R e v e rs e above procedu re to install.
thin p la stic w asher is positioned against the painted
door opening p illa r and center the bolt w asher within
m arks on p illa r.
4. If
door
has
been rem oved and then installed or
aligned in opening, the door should not be closed
com p letely until a visu al check is made to determ ine
if lock cam in door w ill engage the s trik e r bolt c o r-
F ig . 120—S ight C h e c k in g S trik e r B olt A lig n m e n t
STRIKER BOLT MARK
IN PAINT OR GREASE
F ig . 119—S trik e r B o lt A lig n m e n t Points
Make sure the
APPLY PAINT OR GREASE
rectly .
C enter of s tr ik e r bolt should be in d irect
alignment with
" V"
slot in door. If n ecessary, r e
position s trik e r bolt as directed below under " S tr ik e r
Bolt Adjustm ent."
Striker Bolt Adjustm ent
NOTE:
S trik er bolt on cab p illa r is adjustable
v e r tic a lly
and tra n s v e rs e ly after loosening the
bolt with a 5/16-inch hex wrench. The bolt fo re
and aft adjustment is obtained by use of shim
spacers located between the bolt w asher and the
cab p illa r, F igu re 118.
Striker Bolt " Fore" and " A ft" Adjustm ent
1. T o check s trik e r bolt fo r proper fo r e and aft adjust
ment, sm ear grea se or paint to contact side of bolt
(fig. 119)
2. Slowly close door until lock cam of door just con
tacts the side of s trik e r bolt and makes an im p re s
sion in the grea se or paint.
3. M easure distance between head of bolt and the cam
im p ression
in
grea se.
l/8-in ch as shown in figu re
is n ecessa ry to assure that the head of s trik e r bolt
w ill rid e
at cen ter of nylon shoe which is located
just in back of the lock cam.
T o obtain this dim ension, rem ove the s trik e r bolt
and in stall or rem ove shim spacers. Spacers are
available in two thicknesses: 5/64-inch and 5/32-
inch.
Make sure the thin pla stic w asher is located
next to cab p illa r.
BODY IB-51
DOOR STRIKER
CAM MARK
Distance
should
m easure
120.
This dim ension
CHEVROLET TRUCK SERVICE MANUAL