Chevrolet 10 Series 1970 Service Manual page 235

2. P la ce front trunnion in d riv e
yoke on front trunnion. Install one bearin g cup and
seal assem bly in front yoke.
that the snap ring can be in stalled. Install snap ring.
Install rem aining cup and seal in front yoke. Install
snap ring.
3. In stall front trunnion bearin g cups in center yoke in
same manner.
4. With front trunnion com p letely in stalled, in stall seal
on prop shaft (la rg e face fir s t).
1. J -8 4 5 9 S pring Eye Bushing Remover and R eplacem ent
2. J — 21058 S pring Eye Bushing Remover and R eplacem ent
3 . J -7 0 7 9 - 2 D riv e r H and le
4 . J -7 5 7 4 - 6 Series C 20 T ie Rod Bushing In s ta lle r
5. J — 8518 Series C -P 1 0 Tie Rod Bushing In s ta lle r
shaft. P la ce center
D rive in to a depth
Gently slip re a r
Fig. 9 8 — Rear Suspension S pecial Tools
REAR SUSPENSION AND DRIVE LINE 4-59
yoke half on prop shaft using ca re not to upset
r o lle r s . In sert re a r trunnion in cen ter yoke. Install
re a r yoke half b earin g caps on r e a r trunnion. Install
one re a r trunnion bearing cap in cen ter yoke and
p ress into yoke until snap ring can be in stalled. In­
stall rem aining cap and snap ring.
5. B efo re assem bly is rein sta lled in veh icle, grea se
u n iversal as outlined in Section 0 at a ll three (3)
fittin gs (2 conventional type and one (in re a r yoke
half) that req u ires a needle nose grea se gun adapter).
6. J — 8118 Rear S pring Pin P u lle r (Used w ith J — 2619)
7. J-8 4 4 8 Series C -P 1 0 and C -3 0 C o n tro l Arm
Bushing In s ta lle r
8 . J — 2619 S lid e Hammer Assem bly
9. J -2 2 6 2 0 S pring Eye Bushing Remover and In s ta lle r
CHEVROLET TRUCK SERVICE MANUAL