Chevrolet 10 Series 1970 Service Manual page 450

CLUTCHES AND TRANSMISSIONS 7-20
sh ifter shafts. On new p ro c ess m odels, rem ove shift
le v e r rod from shift r a il link.
6. R em ove tra n sfer case to fram e mounting bracket
bolts.
KA 105 BLAZER
Fig. 9 C — Transfer Case M o u n tin g
F ig . 8C —Transfer Case C o n tro ls & M o u n tin g (E xcep t B lazer)
l^VIEW B
7. Support tra n sfer case and rem ove bolts attaching
tra n sfer case to transm ission adapter.
8. M ove tra n sfer case to re a r until input shaft clea rs
adapter and lo w er assem bly from veh icle.
Installation
1. Support tra n sfer case in suitable stand and position
case to transm ission adapter. Install bolts attaching
case to adapter and torque to 45 ft. lbs.
2. Rem ove stand as requ ired and install bolts attaching
tra n sfer case to fram e
assem bly.
3. Install c le v is pins to connecting links between trans­
fe r case and control adapter sh ifter shafts. On new
p rocess model, in stall connecting rod to shift r a il
link.
4. Connect front prop shaft to tra n sfer case front output
shaft. Torque bolts 17 ft. lbs.
5. Connect re a r prop shaft to tra n sfer case re a r output
shaft. Torque bolts 17 ft. lbs.
6. Connect speedom eter cable, back-up lamp and TCS
switch.
7. F ill tra n sfer case to proper le v e l with lubricant
sp ecified in the lubricant section o f the Tru ck Chas­
sis S ervice Manual.
8. L o w er and rem ove veh icle fro m hoist.
CAUTIO N: Check and tighten all bolts to sp eci­
fied torques.
NOTE: B efore connecting prop shafts to com ­
panion flanges be sure locknuts are torqued 250
ft. lbs.
r a il. Bend tabs a fter
CHEVROLET TRUCK SERVICE MANUAL