Chevrolet 10 Series 1970 Service Manual page 89

A D JU STA B LE
H IN G E
F ig . 2 9 —Endgate A djustm ents
5. W h ile supporting the endgate in an u p-right position
rem o ve the rem aining hinge bolt fro m
(See F igu re 28)
6. Rem ove endgate.
7 . R e v e r s e p r o c e d u r e t o i n s t a l l .
Hinges
If n ecessa ry to rem o ve hinges, apply the above steps
and p roceed as follow s:
1. R em ove four (4) bolts fro m
sem b lies on the underside of the body.
2. R em ove hinge a ssem b lies.
i f disassem blin g to rem ove pin.)
3. R e v e rs e procedu re to install.
Adjustments (See Fig. 29 )
Loosen bolts and adjust at eith er endgate hinge position
o r endgate latch as shown in F igu re 29.
ADJUSTABLE
LATCH
each side.
each of the hinge as­
(N ote bushing positions
F ig . 3 0 —Suburban Endgate Assem bly
FORWARD
REMOTE
ASSEM BLY
LEFT SIDE LO CK
ROD A N D SPRING
CLIP
F ig . 3 1 —Endgate Remote and Push Button C o n tro l Assem bly
Remote and Push Button Control Assem bly
Removal and Installation (See Fig. 30 )
1. R em ove rem ote and push button con trol assem bly
access co ver.
2. R em ove spring clip securin g the right side lock rod
to rem ote assem bly. (See Figu re 31.)
3. Rem ove two (2) screw s secu ring the rem ote and push
button con trol assem bly plate.
4. P u ll out the rem ote and push button con trol assem bly
to rem ove the le ft side lock rod sprin g clip: (See
Figu re 32.)
5. Hold the cen ter lock spring le v e r out of the way and
rem ove the con trol assem bly.
6. R e v e rs e the procedu re to install.
BODY IB -11
RIGHT SIDE LOCK
ROD A N D SPRIN G CLIP
GATE
LOCK
CHEVROLET TRUCK SERVICE MANUAL