Chevrolet 10 Series 1970 Service Manual page 217

F ig . 7 6 — 18,500 and 2 3 ,000 lb . Eaton S in g le Speed A x le (1 8 ,5 0 0 lb . A x le Shown)
1. Flange N u t
2 ,. P inion Flange
3. O i l Seal
4 . P inion Cage
5 . A d ju s tin g Shims
6. B earing C up - O u te r
7. B earing C one -
O u te r
The d riv e pinion assem bly and the d iffe re n tia l case
assem b ly a re mounted in the d iffe re n tia l c a r r ie r , and are
rem oved as p art of the c a r r ie r when the c a r r ie r is r e ­
m oved fro m the axle housing.
The d iffe re n tia l is a conventional four pinion type with
rin g g e a r bolted to flanged half o f d iffe re n tia l case. D if­
fe re n tia l case is a tw o -p iece type machined as a matched
assem bly, and must be replaced as such.
Thrust w ashers a re used between d iffe re n tia l side
ge a rs and case, and between d iffe re n tia l pinions and case.
Adjusting rings in the d iffe re n tia l bearin g b o re s of the
c a r r ie r p rovid e fo r adjustment of d iffe re n tia l side b e a r ­
ing p re -lo a d and ring g e a r -d r iv e pinion backlash.
8 . A d ju s tin g Spacer
9. B earing C up - Inn er
10. Bearing Cone - Inner
11. D riv e P inion
12. D iffe r e n tia l C a rrie r
13. Bearing
14. A x le S haft - R.H.
15. D iffe r e n tia l Case
REAR SUSPENSION AND DRIVE LINE 4-41
16. Side G e a r Thrust
W asher
17. Side G e a r
18. Case B olt
19. P in io n Thrust
W asher
20. D iffe r e n tia l P in io n
21. Ring G e a r
AXLE SHAFTS A N D HOUSING
A x le shafts are fu ll-flo a tin g type, splined to d ifferen tia l
side gea rs at inner ends and attached at flanged outer
ends to hubs by studs and nuts. Stud holes in each shaft
flange are ta p er-rea m ed to accom modate sp lit tapered
dowels.
The banjo-type axle housing is on e-piece design with
sprin g seats w elded in place. Brake flange p lates are
rive te d to flan ges w elded on the axle housing tube. Outer
ends of housing a re machined to accom m odate wheel
b earin gs and threads a re cut at extrem e outer ends fo r
installation o f w heel bearin g nuts.
22. Ring G e a r B o lt
23. Bearing C ap
24. Bearing C one
25. A d ju s tin g N u t
26. A d ju s tin g N u t
Lock
27. A x le S haft - L.H .
CHEVROLET TRUCK SERVICE MANUAL