Chevrolet 10 Series 1970 Service Manual page 80

BODY IB-2
1. H eater H ole C o v e r Assem bly
2. H ole Tapping - Dash and Toe
3. Side C ow l V e n tila to r'C a b and W /S C ow l
4. W /S W ip e r M o to r
5. W /S W asher Jar and Hoses
6. W /S W ip e r Linka ge
7. W /S W ip e r Blades
A ll openings that allow dust leaks w ill also p rovid e
w ater leaks. When checking fo r w ater leaks a helper
should be used on the inside of the cab or body to locate
the entrance of w ater, w hile it is applied on the outside.
NOTE: W a ter does not always enter the cab
o r body in the location w here leaks show up,
F ig . 2 — Body M o u n tin g N o . 1
F ig . 1 —C o n v e n tio n a l Cab and C om ponents
8. Pad Assem bly and D efroster O u tle t
9. Ash Tray Assem bly and C over Cab and W /S C o w l
10. Instrum ent Panel C om partm ent
11. Instrum ent Panel C om partm ent D oor
12. W /S and Back W in d o w In s ta lla tio n
13. Transmission C o ve r
14. Dash M ats and F lo or Insulators
th erefo re, back-tracking the path of w ater w ill
show the true entrance of the leak.
WINDSHIELD GLASS
The windshield is a on e-piece type and is retained in
the windshield opening by a moulded rubber w eather­
strip .
opening and sealed to the windshield glass.
When replacin g a cracked windshield glass, it is v e ry
im portant that the cause of the glass breakage to d e te r­
mined and the condition co rre c te d b efo re a new glass is
installed.
obstruction o r high spot som ew here around the wind­
shield opening w ill continue to crack or break the newly
installed windshield esp ecia lly when the strain on the
gla ss caused by this obstruction is in creased by such
conditions as wind pressu res, extrem es of tem perature,
m otion of the veh icle, etc.
The procedure fo r rem ova l of the windshield applies
to the com plete windshield assem bly.
Removal
1. B efo re
of the break on the windshield rubber channel and
the body. P ro te c t the paint finish inside of the cab.
Mask
lay a suitable coverin g a cross the hood and fenders.
NOTE:
strip is one piece.
nel within the w eath erstrip (fig . 8).
2. Do not try to rem ove re v e a l mouldings while wind­
shield
15.
16.
17.
18.
19.
20.
21.
FRONT END
Th is w eath erstrip is sealed in the windshield
O therw ise, it is highly possible that a sm all
rem ovin g the windshield, mark the location
around the windshield opening and outside,
The windshield glass rubber w eather­
The glass is held in a chan­
is in body opening.
Dome Lamp Assembly
D oor Si 1 1 P late
Sunshade and Inside M irr o r
Short and Long Arm M irr o r
Seat B elt In s ta lla tio n
Fuel C a u tio n Plate
Body M o u n tin g
R em ove fro m custom
CHEVROLET TRUCK SERVICE MANUAL