Chevrolet 10 Series 1970 Service Manual page 189

1. C om panion Flange
2. D e fle c to r
3. P inion O il Seal
4. P in io n Front Bearing
5. P inion B earing Spacer
6. D iffe r e n tia l C a rrie r
TORQUE ROD A N D BRACKET
Removal
1. Support the axle housing so that it w ill not p ivot when
torque rod is loosened.
2. R em ove nuts and b olts that secu re the torque rod
bracket to fram e crossm em b er. R em ove spacer and
allow torque rod to p ivot downward until it rests on
housing.
3. Rem ove nut fro m torque rod stud at axle housing
bracket.
Fig. 25— Rear A x le C ross-S e ction (2400 lbs. Through 3600 lbs.)
7. D iffe r e n tia l Case
8 . Shim (A ) w ith S e rvice Shim
9. G aske t
10. D iffe r e n tia l Bearing
11. " C " Lock
12. P in io n S haft Lock Bolt
REAR SUSPENSION AND DRIVE LINE 4-13
13. C o ve r
14. P inion Shaft
15. Ring G e a r
16. Side G e a r
17. B earing C ap
18. A x le S haft
4. Rap surface o f b racket to loosen stud; then, using a
suitable p u ller, rem o ve torque rod stud fro m axle
housing bracket.
5. P osition torque rod and fram e bracket in a v is e and
rem o ve stud nut, then p res s stud fro m fram e b racket
in an a rb or p ress.
Installation
1. Position torque rod
bracket and nut. Torqu e nut to sp ecification s. Install
S H IM A N D
SERVICE
SPACER
19. Thrust W asher
20. D iffe r e n tia l P inion
21. Shim
22. P inion Rear
Bearing
23. D riv e P inion
in a vise and in stall fra m e
CHEVROLET TRUCK SERVICE MANUAL