Chevrolet 10 Series 1970 Service Manual page 84

BODY 1B-6
F ig . 12—C ord In s ta lla tio n
sharply d ecrea se occu rren ce
slam m ing or road shock.
INSTRUMENT PANEL COM PARTM ENT
Replacement
R em oval of the en tire assem b ly including door may be
accom plished by rem ovin g ten screw s just inside box
and com partm ent lamp w ir e (if so equipped). The door
may be rem oved, leavin g the com partm ent intact, by
rem o v a l of four s c rew s and bumper shown in F igu re 17.
A c c e s s to the door stop bum per is gained by reaching
up beneath instrum ent panel.
A ls o shown in F igu re 17 is the lock.
lock in s tr ik e r may be adjusted by loosening s trik e r
retaining s c rew s and m oving
position.
The lock cylin d er may be s e rv ic e d as outlined in Sec­
tion 0, G eneral Inform ation and Lubrication.
INSTRUMENT PANEL COVER ASSEMBLY
The instrum ent panel c o v e r (fig . 18) is secu red to the
instrum ent panel by studs, nuts and screw s.
a re an in teg ra l part of the c o v e r assem bly.
F ig . 13— P u llin g S trin g to Seal Rubber T ip
of fa ilu re due to door
Engagement of
the s tr ik e r to d esired
The studs
- ' .. .i. . > ,
I.:
F ig . 14—Rear S ta tio n a ry W in d o w
Removal and Installation
1. Loosen o r rem ove any n ecessa ry instrum ent panel
item s, g love box, etc.
F ig . 15—Rear V ie w M ir r o r —C o n v . Trucks
CHEVROLET TRUCK SERVICE MANUAL