Chevrolet 10 Series 1970 Service Manual page 90

BODY IB - 12
F ig . 32 — Endgate Remote and Push B utton C o n tro l R eplacem ent
Push Button Assembly
If n ecessa ry to rem ove the push button assem bly, apply
the above Rem ote and Push Button C ontrol steps and
p ro ceed as follow s:
1. Secure the R em ote and Push Button C ontrol A s s em ­
bly and rem o ve two screw s fro m
plate.
2. Rotate the push button assem bly to r e le a s e the lock
assem bly and rem ove.
3. R e v e rs e procedu re to in stall.
Adjustment
Elongated holes with two la rg e
tooth washers are p rovid ed in the rem ote and push button
con trol assem bly plate to p ro vid e fo r needed adjustment.
Lock C ylinder Escutcheon
Removal and Installation
1. Apply above R em ote and Push Button A ssem b ly R e ­
m oval p rocedu res.
2. Rem ove two nuts secu ring the escutcheon.
3. R em ove escutcheon and gasket.
4. R e v e rs e procedure to install.
Endgate Centerlock
1. R em ove fou r (4) s cre w s fro m endgate end.
2. R em ove cen terlock assem bly.
3. R e v e rs e above procedure to in stall.
Endgate Side Lock
1. R em ove Rem ote and Push Button A ssem b ly mechan­
ism a ccess hole cover.
2. R em ove right o r le ft side lock rod spring clip.
3. R em ove fou r (4) s c re w s and lock w ashers.
4. Guide rod and side lock fro m endgate.
5. R e v e rs e procedure to in stall.
PANEL A N D SUBURBAN ENDGATE, LIFTGATE
A N D REAR DOOR STRIKERS—ADJUSTMENT (Fig .3 3 )
Locations fo r s trik e r adjustment are ty p ica lly shown
in F igu re 33. Adjust to dim ension shown and add spacers
as required.
the back of the
screw s and external
F ig . 3 3 —Panel and Suburban E ndgate, L iftg a te and Rear Door
S trik e rs -A d ju s tm e n t
DOOR ASSEMBLY (CAB)
Replacement
R em ove the door assem bly fro m the body by rem ovin g
the hinges fro m the door.
Adjustment
D oor adjustment may be accom plished at two places; at
F ig . 3 4 —Door H inge B olt R e p la c e m e n t-J -2 2 5 8 5
CHEVROLET TRUCK SERVICE MANUAL